Common maintenance methods of electric surgical beds-Foshan Conley Furniture Co., Ltd.

Author: sonkly -GYNECOLOGICAL BED MANUFACTURES

In the long -term electric surgical bed failure maintenance, several fault treatment methods are as follows. 1. If there is no front leaning action and the others are available, it means that the compressed pump is normal. It is the corresponding touch switch or solenoid valve failure. You can use a three -purpose meter to measure the resistance. 2. If there is no front leaning action, there is no other, that is, the compressed pump is faulty, which is generally a disabled capacitance failure.

3. If there is action in one direction and the other direction is not, it is generally caused by the electromagnetic replacement valve, which may be that the mechanical card is killed or the control circuit is broken. First check whether there is voltage. If there is a voltage, you need to clean the directional valve. It is used for a long time. When there is a little impurities in the switching valve active axis, it will be stuck, resulting in only one direction of the electric surgical bed. 4. The electric surgical bed slowly drops slowly during use, which is the failure of the lifting pump.

The solution is to clean up the lifting pump with gasoline, and check the oil inlet valve again. Just replace it with clean oil after washing. 5. The electric surgical bed is automatically dropped automatically in use. This is some small impurities on the leather bowl. The inner wall of the oil pipe will be drawn out. You can replace the lift oil pipe.

.

Recommend：

Beauty Bed Manufacturers

Tattoo Chair Manufacturers

Doctor Chair Manufacturers

Treatment bed Manufacturers

Massage Table Manufacturers

Gynecological Bed Manufacturers

Bar Stools & Chairs Manufacturers

Beauty Bed Suppliers